Tips on how to remove a transmission

If your car needs a new transmission and has experience working on the brand and model of the vehicle can save you money by to do the work themselves. If you have no experience, this is too complicated to take on a task as his first automotive project. Not with the necessary experience really more in the long run will cost it when you set must pay someone to his mistake. Removal and installation of a transmission can be difficult. The weight of the single pieces is something to take into account, rather than in this project. It is recommended that a vehicle lift to work, so you have access to the transmission Jack. Vehicle lifts are not something that fans of every car, so you can be creative, or borrow from a friend at work.

Remove the transmission

Security must be the top priority, when you remove a transmission from a vehicle. Always transmission, and out of the vehicle safely, the vehicle of the shots of the plant should be considered. Intakes should be below the frame in one place, out of the way, allowing the space for the transmission Jack under the vehicle rolling without power. Do you have a good set of cats, you can use a range of heavy duty ramps, but it is advisable to have a number of cats.

Before removing the screws of the transmission, torque converter must rest on the steering wheel. Then, remove the inspection cover. Remove this piece initially allows you easier access to the screws that hold the transmission. You can release a screwdriver between the teeth of the wheel and the gear case screws. For this project, you must remove the shaft also. Transmission fluid should be drained before removing the hub, unless you have available to avoid slipping in the transmission up to the end of a yoke.

Remove the link with transmission and speedometer wiring connected. Also, unplug the wiring of the TCC or wiring harness. Transmission cooling lines must be removed from the housing. In some makes and models of this area is difficult to access and requiring more effort than other models. If its engine rust and corrosion problems can be harder to loosen these parts. If you do not remove these wires and cables it is acceptable to cut as an absolute last resort.

When the transmission has been acquitted of all these parts can move to ensure the transfer and elevation, rising if it is available. Remove the rear fixing screws and increase the transmission to remove the chassis Assembly to make it more easy. Some vehicles have exhaust systems, which are carried out before you have to remove the transmission. Some mechanisms will eliminate recommended, supported the engine to the transmission Bell housing bolts.

The last step does not rise with the transmission. Carefully secure, should be lowered to the ground. Ensure that transfer not forward tilt, while on the floor down and sit the tubes on the unit. Then placed on the ground, the torque converter can be removed to reduce the weight and the transmission much easier to handle. It will be whenever you lose liquid during the movement, the precautions to prevent the dirt in the system. You can transfer the operation lamp or screwed in a Bank while you work to stop or another piece of the beginning of the retained project.